christmas tree lamp

this is a print and then assemble project I both printed and built in a day so it is a nice quick one to do.
I printed the front and back plates in fillamentum gold happens, the power brick was printed in vertigo galaxy by fillamentum and then I printed the diffuser or the clear triangle as it is named in the stls in a sample of clear filament I had from colorfabb

I printed all of these models on the cr-10 using 0.2mm layer heights
once all of the parts are printed I glued the clear triangle to the back of the fancy tree or front plate this will act to diffuse the leds so as not to have bright spots in your swirls.
I then threaded the leds through the hole in the top of the power brick before hot gluing them evenly to the back plate
Note I used micro leds on enamel coated motor wire with a colour change capability
then I fixed the front plate to the back plate using a little glue in the hole then insert the pegs
and last but not least I glued the completed tree/triangle st