MakerWorld
Decor
Model downloaden
Christmas Tree
18
Downloads
8
Likes
5
Makes
Christmas tree with a light compartment in the base. As you can see from the photos, I carved the light control housing into the base so it's a single piece, allowing us to position it wherever we want without any issues. On the back, I drilled a hole where I can use a pin to remove the control when changing the batteries.The star is very small, so be careful when removing the supports, as you might break the pins.If you're printing the tree with the H2 series, you'll need to disable the spaghetti detection and nozzle clog detection features. Otherwise, printing may stop at some point and require your intervention, so I recommend disabling them.
Gettone publiceert ook op
109 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
