Christmas Tree Star

Here is my Christmas tree star using an Arduino and WS2812. It prints with very minimal, if any, support material. Assembly was all light snap fit for me.

NOTE: The STL files were created in inches. Use a scale factor of 25.4 if you are using millimeters.

Print the following:
3X Star_Point_Default
2X Star_Point_Support
2X Star_Cap_Default
10X Star_Clip_Default
1X Star_PCBHolder_Default
1X Star_PCBHolder_Mate
1X Star_Base_Default

I also put a triangular piece of cardstock (template STL file included) in the middle of each point to minimize bleed.