christmas tree xmas tree

This model is about 20cm tall, and due to overhangs when printing in vase mode, it is needed to be printed with big nozzle and thin layers

I succeed with 0.8 mm nozzle, with 1mm extrusion width, and 0.2mm layer height. 30mm seconds print speed.

When scaling down 50% it would be possible to print 0.4 nozzle with 0.12 layer height (but I have not tried myself)

If you scale up, respectively lower the layer height say 0.12 (with 0.8 nozzle) - again I have not tested that.

Note the model is not mine, but I scaled it - I found it in thingiverse - https://www.thingiverse.com/thing:1978142