Chuck Glider

**PLEASE SEE REMIX. THIS DESIGN HAS BEEN SUPERSEDED BY REVISION**

A hand launched chucking glider for indoor/outdoor use. This construction favors high launch speeds and straight throwing for best performance. The final construction should weight approximately 150g (+/-15g ) and its center of mass sits at or slightly forward of the center of lift.

No supports should be required for printing and I highly recommend using rafts, or at a minimum a brim. It is assembled by supergluing the wing segments into their respective recessed pockets, and the nose cone threads into the main fuselage for easy swaps in the event of any unrecoverable failure.

LWPLA is not necessary for this print, but can be used.

Project f3d and step files have been included for any edits you consider that I hadn't.

**Specifications:**
* 300mm Wingspan
* 70mm Chord
* 5° Dihedral
* 5° Pitch of Horizontal Stabilizers
* Tip Plates for increased vertical stability and to alleviate tip vortices
* Printable on 180x180