Cigarette Pack Holder - Wall (remix)

I remixed the (Cigarette pack + lighter holder) by Jewcookie to be able to mount it to the wall in my garage, where I always smoke. First, I removed the lighter holder as it didnt fit the Bic lighters that I prefer. The walls on the original were already thin as it was, and my laziness took over and I left it that way (I may revisit that later). So long as you are gentle setting the screws it works just fine.

Jewcookie thought it may only fit Marlboro, but it fits my Luckie's just fine. The dimensions of the pack are roughly 56mm x 22mm if you want to check your pack before printing. Anything smaller will work fine as well.

Printing, I used a raft only because my print bed is old and warped slightly, otherwise you don't need rafts or supports. Seeing as the walls are only 1mm thick, I printed at 100% infill, i doubt you really get a choice with that one anyways.