Ciggarette lighter splitter.

Needed two lighter sockets in my truck, that has only 1, i quickly made this after finding no other suitable models. Tested it with about 5 different models of plugs, they all fit very snug.

For the positive (+) connection you need 2 M3 bolts, about 10mm long. 4 M3 washers and 2 M3 locking nuts.
Screw the bolt thrue the bottom from the inside. Put on 1 ring, twist wire around thread. Put on second ring and secure with nut.
For the negative (-) connection i soldered 2 wires to 2 22mm OD keyrings, that slot into place in the model.
There is a channel for the negative wire. Cap has to be glued on.

This has been made in tinkercad, as you can see by the not so round circles...
Please be gentle, 1st upload on here!

Printed in Jayo PLA+ at 0.2, 100% infill.