CineWhoopPH

Printable CineWhoop that's finally light enough.
Weight of completed frame is 25g.

Warning: This is pre-release version and it is not fully tested.
In plan is to test the frame and do modification for 1616 stack and nano camera. Also I will do versions for 9x9 motor holes and holder for naked GoPro.

The completed cineWhoopPH on photos is with older version of frame.
Photos of newest frame will come later.

Designed for:
2020 stack
micro camera
Motor holes are 12x12 actually I'm using 1404
2.5inch props

GoPro holder is designed for full GoPro Session (My plan is to create also holder for naked GoPro)

For completion you need only 4x M2x5 or M2x7 screws for bottom bracer and 3x M2x7 and 3x M2 nuts for GoPro holder.

Suggested battery is 4S450mAh or equivalent if you want to use higher kv motors with 3S.

If you like this project you can support it via PayPal:
https://paypal.me/petrhomolka