Slicer Discord
Circle Aid – 3D-Druckmodell von Thingiverse Thingiverse

Circle Aid

von Marfie
633 Downloads
415 Likes
0 Makes
Zum Modell
This is a simple aid for drawing curves or circles from 1 to 10cm radius. The are no sizes on it because it is intended for use in simple notebooks or diaries where the actual measurements are irrelevant.

The centre can be visually positioned by using the hole through the Bush. A finger on the Compass Rest holds it in position so a pencil or pen can be put in the appropriate hole to draw a curve or circle.

If a particular size is needed then lines can be made on the page first and a suitable pencil hole chosen.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

1 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen