MakerWorld
Signs & Logos
Zum Modell
Circle Drawing Stencil V2
7
Downloads
1
Likes
0
Makes
Improved upon model from the previous V1 that had a lot of flaws that included the M3 screw damaging the wood piece which is now fixed with a standard pushpin that is covered up with a cover. This model does need a bit of assembly which is shown below. THIS MODEL NEEDS A BUILD PLATE ATLEAST 250mm.Step 1Push a standard pushpin into the hole at the end of the stencil.Step 2Cut the pushpin at this lineStep 3Insert the top cap onto the end of the stencil.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
