Citadels Classic Insert - Square box

This is an insert for the Citadels Classic box. It is a square box about 12cm per side and about 4cm deep: if you have a different box this will not work for you.

The insert has a chamber for cards with a cutout so you can get them out, and two smaller chambers for coins and crowns. It is a tight fit, so if your printer over-extrudes on corners you may have to sand or shrink the model 1%. That is about as far as I would suggest shrinking to ensure the cards still fit.

The coins I am using are these, but I shrink the height and width to 50% and keep the coin thickness at 100%:
https://www.thingiverse.com/thing:3680555

And the crown I am using is this:
https://www.thingiverse.com/thing:2346465
Which I printed slightly compressed vertically.