Clamp Lamp Bracket

Created a bracket for attached a clamp light to any way. I use it to clamp a 150W heater bulb above my printer to heat the print area in a cold room instead of using an enclosure. However can be used to as a mounting location for a heat lamp or light in any location.

A post is included to help guide the power cord to the wall and keep the wire off the lamp.

Ridges are also included to the back to help resist twisting and allow mounting with a single screw.

I suggest using wall anchors if installing into drywall and use of a washer under the screw head to ensure the screw can be tightened sufficiently without damaging the mounting hole.

The Lamp I can be found here at the moment: https://www.amazon.com/dp/B08VDGH4ZS
(150W Ceramic Reptile Heat Lamp Bulb and 8.5 Inch Reflector Clamp Light Combo)