Thingiverse
Clamping hand with rubber loop
by darkfrei
0
Downloads
2
Likes
0
Makes
Proof of concept of the holding clamp.
Screw on nut: standard or printed.
Printed thread: like M8, but the thread pitch 2 mm instead of 1.25 mm and thread angle 90 degrees instead of 60 degrees.
https://youtube.com/shorts/iasAuAgq5TE
https://www.youtube.com/shorts/iasAuAgq5TE
Screw on nut: standard or printed.
Printed thread: like M8, but the thread pitch 2 mm instead of 1.25 mm and thread angle 90 degrees instead of 60 degrees.
https://youtube.com/shorts/iasAuAgq5TE
https://www.youtube.com/shorts/iasAuAgq5TE
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
