Thingiverse
Clamping Screw Bowden PTFE
von dreiduke
11
Downloads
2
Likes
0
Makes
This Clamping screws replace the common bowden clamps.
G9.728x0.907 thread is for most Hotends, and some Extruders like the dualdrive from Winsinn.
M6 is for most Extruders.
If M6 needed:
I recomment to Print M6 inner oder M6 inner long, and the use of a M6 Tube like these tubes between hotend heatsink and hotend heat block.
PLA Works Well, PETG is a bit stronger.
Infill: at least 80%
Layer: 0.12
Support: no
Adhesion: Brim
The Tape is just to visualize if it works.
G9.728x0.907 thread is for most Hotends, and some Extruders like the dualdrive from Winsinn.
M6 is for most Extruders.
If M6 needed:
I recomment to Print M6 inner oder M6 inner long, and the use of a M6 Tube like these tubes between hotend heatsink and hotend heat block.
PLA Works Well, PETG is a bit stronger.
Infill: at least 80%
Layer: 0.12
Support: no
Adhesion: Brim
The Tape is just to visualize if it works.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!