Thingiverse
Clamps Holder
par Elad28
2
Téléchargements
4
Likes
0
Makes
Note that the thickness of your clamp is not more than 16 mm
and the width between the rail and the screw handle is not less than 40 mm
After printing:
If you print like in the demonstrating picture from the slicer you most break the support.
Use a 2 sided sticky tape to attach the holder to the desired surface.
the clamp used in the picture is 50x250 mm.
and the width between the rail and the screw handle is not less than 40 mm
After printing:
If you print like in the demonstrating picture from the slicer you most break the support.
Use a 2 sided sticky tape to attach the holder to the desired surface.
the clamp used in the picture is 50x250 mm.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
