Thingiverse
Clamshell Wire Grommet
door cbanakis
12
Downloads
18
Likes
0
Makes
Made these to run wires with bulky plugs through a drop ceiling.
Prints without any supports.
Covers a 26mm - 50mm opening.
Supports wires up to 10mm thick.
Plugs can be up to 20mm.
(The size of the nut opening)
Also made a slotted nut to accommodate any size plug, and a longer bolt with a 15mm opening for thicker cables.
The 15mm one is harder to assemble because there's no room for alignment tabs.
Prints without any supports.
Covers a 26mm - 50mm opening.
Supports wires up to 10mm thick.
Plugs can be up to 20mm.
(The size of the nut opening)
Also made a slotted nut to accommodate any size plug, and a longer bolt with a 15mm opening for thicker cables.
The 15mm one is harder to assemble because there's no room for alignment tabs.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!