Thingiverse
Classy Bowtie
by heytiger
133
Downloads
78
Likes
3
Makes
This bowtie prints without support. There is a slot in the back which will fit over standard shirt buttons.
If you want to change the colors as I did, watch your print around 46% when and change the filament when you see it start to make the inner perimeter. Then change it again around 97%, once it is only printing the center knot. I finished this one off by coloring the remainder of the knot with a sharpie.
Follow me for more useful things.
If you want to change the colors as I did, watch your print around 46% when and change the filament when you see it start to make the inner perimeter. Then change it again around 97%, once it is only printing the center knot. I finished this one off by coloring the remainder of the knot with a sharpie.
Follow me for more useful things.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!