Thingiverse
Claw foot
12
Downloads
11
Likes
1
Makes
I need to print some feet to stand up an MDF board vertically so I downloaded a sculpting app and sculpted the most horrible foot I could.
I'll cut a slot in the foot to accept the board, add a hole for a screw to secure it, then mirror it to get a symmetrical pair.
In the slicer I'll cut off the very bottom to make sure there are several flat contact areas in the same plane for stability.
I'll cut a slot in the foot to accept the board, add a hole for a screw to secure it, then mirror it to get a symmetrical pair.
In the slicer I'll cut off the very bottom to make sure there are several flat contact areas in the same plane for stability.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!