Thingiverse
clay cactus mix
von annaa
66
Downloads
68
Likes
2
Makes
Printed on a delta clay printer. You can mix pots and catus as you like
i use cura for sclicing
The pot is printed with 30% infill, layer hight is 1 mm. No infill in top and bottom.
The catus is printed as a shell 'spiral the outer counter' layer hight 0.8 mm
i use cura for sclicing
The pot is printed with 30% infill, layer hight is 1 mm. No infill in top and bottom.
The catus is printed as a shell 'spiral the outer counter' layer hight 0.8 mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
