Electronics
Model downloaden
Cleito Tank Drip Tip
87
Downloads
70
Likes
2
Makes
This is a replacement drip tip for a Cleito by Aspire sub-ohm tank for vaping.
This tip just slides on like the stock drip tip. I feel like you get much more airflow, and the smooth round edge gives it a great feel in the mouth. The higher resolution you print this, the better that will feel.
DISCLAIMER: I have only printed this in M3Ds Tough Ink filament. This is a very flexible filament and works perfectly for this project. However; I have not printed this in a rigid filament, so I cannot attest to the fitment or tolerance of this part. If it is too tight, or too loose with a rigid filament a little scaling on the X and Y could get you where you need to be.
This tip just slides on like the stock drip tip. I feel like you get much more airflow, and the smooth round edge gives it a great feel in the mouth. The higher resolution you print this, the better that will feel.
DISCLAIMER: I have only printed this in M3Ds Tough Ink filament. This is a very flexible filament and works perfectly for this project. However; I have not printed this in a rigid filament, so I cannot attest to the fitment or tolerance of this part. If it is too tight, or too loose with a rigid filament a little scaling on the X and Y could get you where you need to be.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!