Clevo P770DM

This is a remix of the P775 Feet for permanent or temporary attachment to my P770DM. The original was covering up some of my vents and was just too big.

I took the original into Tinkercad and made it smaller in the X and Y Axis until the big end was the size of the old small end. Then I took a negative of the cutout and put it back in so it would fit over the laptop feet. I made the well 3mm deep so the original feet should fit inside depth wise. (see below about the size of the feet.)

I recommend flipping it upside down and making a mirror copy for the other side foot. Also it is a little bit too small on the hole to fit over the laptop's foot, maybe scaling it 1-2% would work. I didn't worry about that because:

I used some thick 3M UHB double sided adhesive strip to attach it permanently. And some foam rubber furniture anti-slip for the bottom side.

Printed in PLA on Ender 3
small end down (no support needed)
0.2mm layer height
20% infill

Scale up 1 or 2% if