Climbing Finger Blocks

These are some Fingerblocks I designed to maintain some finger strength during Covid-19.

They're designed with holes to hang them from rope. I live in a rented place at the moment so couldn't screw into the walls but had the opportunity to hang some ropes up in the garage.

I'd recommend printing in an engineering material like PETG or ABS. Something like fuzzy skin in Cura is nice to give them a bit of texture, or you can just turn all the retractions off, up the temperature and use the strings and blobs instead.

I'd rate these as "Fairly Easy" as far as finger blocks go, the pockets are relatively deep and wide but there's no lip or undercut. Might give a more difficult variant a go in the future. Maybe try and make it less filament hungry too.

Check Out: https://tinker.life/2020/05/08/printed-finger-blocks/