Climbing Training Block

This is a multi-function climbing grip/finger strength trainer. **The strength of 3D prints can vary significantly depending on the calibration/filament/temperature/etc. Use at your own risk** Includes:100mm, 60mm, 40mm, and 20mm pinches20mm, 16mm, 14mm, and 10mm edgesMono pocketSloperRequires: Super Glue or other suitable adhesive8mm or smaller ropeWeights (to lift)Clamp or hammer (optional)Designed to be printed in two halves with perpendicular layer directions and glued together to optimize strength and avoid any tension loading normal to the layers. The bottom half extends through most of the top half as reinforcement. The textured model uses fuzzy skin for additional grip (0.3mm distance, 0.5mm thickness). The fuzzy skin adds a significant amount of time to the print so I've also included a “No-Tex” profile for faster printing. Assembly:Clean up any supports, strings, or droopy bridgesPartially test fit the pieces together to ensure no major interference. Do not fully insert a