Thingiverse
Clipper Spool Case
von thecreamymeme
2
Downloads
3
Likes
0
Makes
Clipper lighter Case/Sleeve/Holder. This time with a rotating spool and 2 eyelets.
1:Print the 2 parts
2:Drill out the hole in the bottom of the sleeve.
These next two steps can be done in any order:
3:Insert Spool into Sleeve
4:Melt top of peg that's on top of Spool ensuring that it now stays in, yet rotates.
VERY IMPORTANT:
A neat feature: you can fill up your clipper just by taking the spool off.
Another neat feature: You can depress the fill port with the peg of the spool if it's not
melted correctly. Let me know if there's any unreasonable issues.
1:Print the 2 parts
2:Drill out the hole in the bottom of the sleeve.
These next two steps can be done in any order:
3:Insert Spool into Sleeve
4:Melt top of peg that's on top of Spool ensuring that it now stays in, yet rotates.
VERY IMPORTANT:
A neat feature: you can fill up your clipper just by taking the spool off.
Another neat feature: You can depress the fill port with the peg of the spool if it's not
melted correctly. Let me know if there's any unreasonable issues.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
