Clipping extruder push

Tested on Anet A8
Another one, just to avoid ruining your fingers .... and to loose the thing or get it falling upon the bed when moving the printer or by accident. This push helper for the extruder clips nicely in both dimensions around the Anet A8 screw, and stays in position in all cases.
Designed with Tinkercad. If I had to redesign it, I would shorten the clipping parts (the ones dedicated to bend) by 3 or 4 mm, as the clipping is efficient but not as hard as anticipated, a new design could save a few milligrams of PLA...
As I only put 50 microns between parts that are supposed not to touch, a cutter might be needed to split them after printing.
Fonctionnellement, il fera la même chose, épargner vos doigts. Mais il évitera de tomber sur le plateau , car clippé dans les deux dimensions sur le tête de vis.
Fait sous tinkercad. A refaire, je ferai les pattes de flexibilité un peu plus courtes, de 3 ou 4 mm, car la pièce se clippe très facilement, et n'a pas besoin d'autant de