Thingiverse
Clone's brush holder
by Brown_Bear
10
Downloads
22
Likes
0
Makes
This is a 2D style clone phase 1 mask with the purpose of holding your tootbrush, paint brushes, or anything you can fit in a 15x15x60 mm hole.
The rough dimensions of the head are 50x40x70 mm.
You can print it stand-up to have a nice finish, but you'll need few tiny supports, or flat for a quick print.
I recommend making 5-8 solid bottom layers, and you can lower the infill to 5%, so at the end it will result in a 3/4 hour print.
I used white pla and than painted it with acrilic paints.
Hope you like it
The rough dimensions of the head are 50x40x70 mm.
You can print it stand-up to have a nice finish, but you'll need few tiny supports, or flat for a quick print.
I recommend making 5-8 solid bottom layers, and you can lower the infill to 5%, so at the end it will result in a 3/4 hour print.
I used white pla and than painted it with acrilic paints.
Hope you like it
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
