Thingiverse
Cloth Hanger Joint
by letscho2k
0
Downloads
0
Likes
0
Makes
Another plastic part in my house broke, so i decided to replace it...
This comes from a rolling hanger rack that I use, the diameters of mine are:
1 1/8in to the center & 1 1/8in to the bottom & 1in to the side
The fit from my printer was nice and tight so I recommend you use a nylon or rubber hammer to give it few good taps in order to install. I printed mine without supports.
*Edit: I added the end cap for the 1" side, you will still only need the hammer to install.
This comes from a rolling hanger rack that I use, the diameters of mine are:
1 1/8in to the center & 1 1/8in to the bottom & 1in to the side
The fit from my printer was nice and tight so I recommend you use a nylon or rubber hammer to give it few good taps in order to install. I printed mine without supports.
*Edit: I added the end cap for the 1" side, you will still only need the hammer to install.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
