Thingiverse
Cloth Hanger
von Catweazel
8
Downloads
4
Likes
0
Makes
Hello,
this cloth hanger is printed in three parts. Those can be connected via 3mm bolds and some 3mm thread inserts. Only glueing might be an option as well. If you like I can make a glue only version without holes.
Supports only needed for the step in the holes. I Printed with a 0.6mm nozzle and 0,3mm layer height. Use a few parameters for making it strong. Note that the left and right part are upside down in the STL files!
this cloth hanger is printed in three parts. Those can be connected via 3mm bolds and some 3mm thread inserts. Only glueing might be an option as well. If you like I can make a glue only version without holes.
Supports only needed for the step in the holes. I Printed with a 0.6mm nozzle and 0,3mm layer height. Use a few parameters for making it strong. Note that the left and right part are upside down in the STL files!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
