Cloth Mask Support

This is a simple support for the common cloth masks being used a lot recently.

I had an issue with some of these masks where they end up in my mouth while I speak, which, in turn, pulls them off of my nose. I needed a quick fix, and since I just got a 3D printer, decided to do something simple with it.

To place a brace, start by placing the two ends wedged behind the elastic band.
Then, pull the outside edge into the small hook in the center of the brace (try to bunch the fabric so it holds better).
Repeat on the other side with another brace.

It's a simple fix, but it works pretty well. I tried to get the measurements to work best with a few masks of this style, but, if the fit isn't perfect, feel free to leave notes if you try it.

I will be adjusting this design to try and further improve support and maintain a better seal.