Thingiverse
Clothes Peg
von Petal3D
26
Downloads
18
Likes
0
Makes
Use these pegs to hang up your clothes or use the wide version to label stuff. I created these pegs to use up my collection of short filament lengths. Each clothes peg half uses about 1 metre of 1.75mm filament. I suggest printing with 100% infill.
Use springs from standard wooden clothes pegs. Ideally, reuse the springs from weather-beaten clothes pegs. Print some clothes pegs in glow-in-the-dark filament! (The light blue ones are.)
There are three types of files: single print of half a clothes peg, double print for a complete clothes peg, and a wide version of the gripper end.
Update 2025/06/03: Rev03 - increased spring diameter; increased width; chamfered edges; increased resolution.
Use springs from standard wooden clothes pegs. Ideally, reuse the springs from weather-beaten clothes pegs. Print some clothes pegs in glow-in-the-dark filament! (The light blue ones are.)
There are three types of files: single print of half a clothes peg, double print for a complete clothes peg, and a wide version of the gripper end.
Update 2025/06/03: Rev03 - increased spring diameter; increased width; chamfered edges; increased resolution.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
