Slicer Discord
CloverPlus Smooth Rod Brace – 3D-Druckmodell von Thingiverse Thingiverse

CloverPlus Smooth Rod Brace

von xunker
0 Downloads
0 Likes
0 Makes
Zum Modell
Brace for the Z-Axis smooth rods of [my CloverPlus](https://www.thingiverse.com/make:208007) (a make based on [the original V2](https://www.thingiverse.com/thing:1374313)) printer, though they should work for anything that needs two rods joined together.

This helps reduce chassis flex and sway when then effector makes large, fast moves. It can also give a hardpoint to attach things to the towers.

To assemble each you will need:
* Print both pieces (screw side and nut side)
* 9 M4 nuts
* 9 M4 flat or button-cap screws (about 10mm long). Do not use machine screws (countersink or V-shaped head), they will just split the plastic

Place the M4 nuts in each slot on the "nut side", then place both pieces on your Z-tower ( **below** your carriages, of course) and tighten those babies down until nothing moves. You're done!

Again, remember to place them **below** your carriages.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Schleifen, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen