Thingiverse
Clutch pedal (game controller)
door Mape
207
Downloads
186
Likes
1
Makes
A custom made clutch pedal extension for Logitech Driving Force GT.
Fits next to the original pedal set. I plan to screw those together.
In addition to the printed parts you will need
- a long enough 6 mm bolt or a piece for 6 mm threaded rod
- couple of 6 mm nuts and spacers
- 4 x 3mm screw to connect the pedal to the pedal arm
- possibly some screws to mount everything on a platform
- electronics to drive the thing
For electronics I used a PIC18F2550 microcontroller on a stripboard to read input from a limit switch connected to the pedal assembly and to provide USB connectivity. Photos and a Lochmaster 4 files are included to show the stripboard design. Board is installed inside the pedal.
Included source code for PIC18F2550 requires CCS C compiler to build.
Fits next to the original pedal set. I plan to screw those together.
In addition to the printed parts you will need
- a long enough 6 mm bolt or a piece for 6 mm threaded rod
- couple of 6 mm nuts and spacers
- 4 x 3mm screw to connect the pedal to the pedal arm
- possibly some screws to mount everything on a platform
- electronics to drive the thing
For electronics I used a PIC18F2550 microcontroller on a stripboard to read input from a limit switch connected to the pedal assembly and to provide USB connectivity. Photos and a Lochmaster 4 files are included to show the stripboard design. Board is installed inside the pedal.
Included source code for PIC18F2550 requires CCS C compiler to build.
Mape publiceert ook op
99 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
