Thingiverse
CM.127 Thread adapter
von TheEggi98
1
Downloads
3
Likes
0
Makes
Because the hexagon-shaped muzzle of the CM 127 is a glued inset, i measured the inset and added it to the thread adapter from DEX_Builds.
I only needed my deburrowing tool for some fitting and glued it in place.
Didnt tested on field yet, but some homeshooting with a T238 tracer of 190g was fine.
I only needed my deburrowing tool for some fitting and glued it in place.
Didnt tested on field yet, but some homeshooting with a T238 tracer of 190g was fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
