Thingiverse
CNC Simple Probe V1
von Jocman
7
Downloads
2
Likes
0
Makes
As I need to install a probe on my CNC (well, the workplan is not perfectly flat, so I've to cheat it), I designed this small probe.
Just need it a microswitch and a small rivet, 2 M3 screws, some wires and a nail.
As the rivet is to long, I used an old ballpen plastic refill to limit its depth.
Originally, the probe was created to be inserted into the mill's chuck, later I decided to expoxyglue it to a slide to mount it on the shoulder installed on my Z axis
See my other Things about CNC)
Well, till now all my test have been positive, the probe works fine.
Just need it a microswitch and a small rivet, 2 M3 screws, some wires and a nail.
As the rivet is to long, I used an old ballpen plastic refill to limit its depth.
Originally, the probe was created to be inserted into the mill's chuck, later I decided to expoxyglue it to a slide to mount it on the shoulder installed on my Z axis
See my other Things about CNC)
Well, till now all my test have been positive, the probe works fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
