Slicer Discord
CO2 Rocket – 3D-printbaar model van Thingiverse Thingiverse

CO2 Rocket

door 24mhaggag
5 Downloads
8 Likes
0 Makes
Model downloaden
This is a rocket that uses a 12 gram CO2 canister meant for BB guns to propel itself about 50 feet in the air. We used this PVC pipe with a nail in the bottom to puncture the seal at the bottom of the canister. The pressure released from the compressed canister launched out the rocket. The launcher is easy to build. We just used a piece of wood with a nail in it. It is important that the nail is centered and sharp. To launch the rocket, put a co2 canister in the rocket and put the nose cone on. Put the rocket in the tube and hold with your thumb. Than slam down on the rocket as hard as you can. The harder you do it, the higher it will go. Our testing estimates that this rocket went about 50 feet. Sadly, we could not put a photo of the printed rocket because in our second test, it fell on the third floor of a currently renovating building. Just goes to show how high it goes.
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Wood PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie