Thingiverse
Coaster Holder
por kingzor100
1
Descargas
0
Likes
0
Makes
I printed it with abs but pla should be fine. i printed at 25% infill and its sturdier than i thought it would be i used ironing on top
Cubic 25% infill
3 Walls
0.2 mm layer height
i used Brim at 4 rings
it came out at 100g
Cubic 25% infill
3 Walls
0.2 mm layer height
i used Brim at 4 rings
it came out at 100g
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
