MakerWorld
Other House Models
Zum Modell
Coaster Saver/Coaster Shell – Parametric Model
6
Downloads
5
Likes
1
Makes
The idea behind this model is pretty simple. I had a couple of cork coasters that started to disintegrate, and I also had some leftover filament that was not enough for any of my prints. So why not save both of them at the same time?Being a parametric model, you have to input the width and the height of the coaster. Make sure the dimensions are as accurate as possible to avoid any gaps.After the print is done, just glue to coaster to the Coaster Saver, and you are good to go.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
