COB LED Strip Light - USB

MATERIAL1 - USB-A Power Cable with PH2.0 Connector2 - 40x36x126 mm Clear Acrylic Rigid Round Tube (1 tube)3 - D5x2 mm Round Magnet (4 magnet)4 - BT2x8 SHCS Self Tapping Screw (3 screw)5 - PH2 to SH1 connectorASSEMBLY1 - Take 3 of your 4 magnets, and insert them into the molded part that will go on top of your lamp (you can also help yourself with glue in case you need it). 2 - Now take the smallest piece of all and glue on the remaining magnet, making sure that the magnet attracts with the 3 put in before, otherwise your lamp will not work. 3 - Take the led and pass it inside the base passing from underneath, once passed you can glue the piece prepared in step 2 to your led with glue. 4 - With PH2 to SH1 Connector (RECOMMENDED)Use the converion cable to connect the usb cable to the led board. NO PH2 to SH1 ConnectorCut the connector from your usb cable (the white end part), and pass it inside the base. Once passed you can solder the wires to the led's power board. Solder the red wi