Thingiverse
CobbleBot X axis belt block
door CthulhuLabs
17
Downloads
4
Likes
1
Makes
A block to attach the X axis belt to rather than the silly screw that comes with the printer. I used that same silly screw to hold down this block. I also had to use a few washers to get the height adjusted properly.
Update:
Check out this remix: http://www.thingiverse.com/thing:1072943 Its much better.
Update:
Check out this remix: http://www.thingiverse.com/thing:1072943 Its much better.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
