Thingiverse
Cobra ACA-004 brackets
von Harveyzone
0
Downloads
0
Likes
0
Makes
A pair of brackets to hold down a Cobra ACA-004 8 channel mixer.
I got a bit fed up of any movement in the cables pulling it about, so I threw together a couple of screw down brackets to hold it in place which seem to do the job.
You will need to trim off the little angle piece on the front of each bracket which I added so that I could print without supports, which it just about does on my Ender3, but the angle is just about on the limits of what it can cope with.
I got a bit fed up of any movement in the cables pulling it about, so I threw together a couple of screw down brackets to hold it in place which seem to do the job.
You will need to trim off the little angle piece on the front of each bracket which I added so that I could print without supports, which it just about does on my Ender3, but the angle is just about on the limits of what it can cope with.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!