Thingiverse
Cockroach kiddyproof bait holder
von bellliam
2
Downloads
3
Likes
0
Makes
I designed this trap so my infant couldn't touch the bait or easily remove it. I printed at 0.2mm layers with no brim and supports from build plate only in PETG.
There are two kinds, a wall mounted and a floor mounted. You can use a large size command strip to hold them down.
Use a butter knife or something thin to slide in between the lines to pull out the bait holder.
There are two kinds, a wall mounted and a floor mounted. You can use a large size command strip to hold them down.
Use a butter knife or something thin to slide in between the lines to pull out the bait holder.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
