Thingiverse
Coco - Animal Crossing
por TheDapperClam
165
Descargas
161
Likes
0
Makes
Fan art of Coco from Animal Crossing, model made by me. Base plate is two pieces so you can put NFC inside if you'd like.
My recommended procedure would be:
1. Print out everything
2. Remove any support material
3. Make sure the figure fits into the bottom piece of the base plate, don't glue yet
4. Sand any rough spots (I used 200 grit sandpaper)
5. (Optional) place NFC into bottom piece of the base plate, make sure it works before gluing pieces together
6. Glue figure and bottom piece of base plate together (I used super glue)
7. (Optional) clean, paint, and put a protective coating on your figure
My recommended procedure would be:
1. Print out everything
2. Remove any support material
3. Make sure the figure fits into the bottom piece of the base plate, don't glue yet
4. Sand any rough spots (I used 200 grit sandpaper)
5. (Optional) place NFC into bottom piece of the base plate, make sure it works before gluing pieces together
6. Glue figure and bottom piece of base plate together (I used super glue)
7. (Optional) clean, paint, and put a protective coating on your figure
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!