Thingiverse
Cocoon Create Touch/Wanhao Duplicator I3 Plus Spool Holder Riser
por ecitta
0
Descargas
0
Likes
0
Makes
I bought a roll of filament where the spool reel itself seemed to be slightly larger than standard, so I found that it would not fit on the stock spool holder without hitting the top of the printer.
Quickly mocked up this 5mm spacer to lift the spool holder so that the larger spool cleared. You may need to replace the two screws with slightly longer ones if the ones included with your printer are too short.
Made for Cocoon Create Touch/Wanhao Duplicator I3 Plus.
Quickly mocked up this 5mm spacer to lift the spool holder so that the larger spool cleared. You may need to replace the two screws with slightly longer ones if the ones included with your printer are too short.
Made for Cocoon Create Touch/Wanhao Duplicator I3 Plus.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!