Thingiverse
Coffee spoon holder
von Qubiq
0
Downloads
1
Likes
0
Makes
I was getting annoyed with the combo spoon / tamper than came with my small Krups coffee machine getting everywhere and leaving ground coffee on the benchtop.
This small spoon holder just captures the spherical part of the spoon.
I printed it with a brim that I actually ended up keeping with the print so that I had extra surface to attach it to the side of the machine with double sided tape.
It's only a one hour project so it might take some extra improvements if you're keen to remix it.
This small spoon holder just captures the spherical part of the spoon.
I printed it with a brim that I actually ended up keeping with the print so that I had extra surface to attach it to the side of the machine with double sided tape.
It's only a one hour project so it might take some extra improvements if you're keen to remix it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!