Thingiverse
Coffee Tamper
von Somebody6868
8
Downloads
3
Likes
0
Makes
Just a traditional coffee tamper all in one piece. For getting a nice flat top on your grounds when you make espresso coffee. Works for Breville coffee makers.
I printed this one out of PLA at 20% infill. It prints well when it is flat side down.
I printed this one out of PLA at 20% infill. It prints well when it is flat side down.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!