Slicer Discord
Coin and small items interlocking holder – 3D-Druckmodell von Thingiverse Thingiverse

Coin and small items interlocking holder

von konto89
108 Downloads
52 Likes
0 Makes
Zum Modell
A friend of mine asked me if I could make a holder to have the coins under his cash register, so I made these interlocking boxes that can be used also to organise the desk!
They have two male and two female locks so they can be connected in many ways!
Each compartment is 8cm x 8cm x 4cm and has a small slope in one side so it is easier to remove any item from inside!

I used .3mm layer height and found that it is best to have 7 to 10% infill!
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Warum?
0.30mm Schichten
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Schichthöhe
0.3 mm
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

konto89 veröffentlicht auch auf

13 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

2 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen