Thingiverse
Coin Box
von Oneill_2l
0
Downloads
2
Likes
0
Makes
Hello,
My Grandma had some silver Coins and needed a Box for them. So i created this. A box for small and Big Coins.
The splits for the Coins are 2,8mm thick and the biggest coin should be not bigger than 50mm.
In the Corners of the Box and the Lid is space for small, round 2x6 magnets (2,2*6,4).
!! Don't forget the Break in the Slicer for the Magnets!!
Magnets:
https://amzn.to/4qsFQOk
PLA is good enough.
Have Fun.
(I would appreciate a little Tip. Thanks)
My Grandma had some silver Coins and needed a Box for them. So i created this. A box for small and Big Coins.
The splits for the Coins are 2,8mm thick and the biggest coin should be not bigger than 50mm.
In the Corners of the Box and the Lid is space for small, round 2x6 magnets (2,2*6,4).
!! Don't forget the Break in the Slicer for the Magnets!!
Magnets:
https://amzn.to/4qsFQOk
PLA is good enough.
Have Fun.
(I would appreciate a little Tip. Thanks)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
