Thingiverse
Coin Cell Insert; 2x cr2032
door Trancor
6
Downloads
5
Likes
0
Makes
Decided to convert those cr2032 battery powered LED strips into USB powered.
There will probably be an instructable to come.
This should fit any of those coin cell LED strips, this is a common housing, well, that I've seen.
Printed at 1.5mm layer height for mine; I can only assume 2mm would be fine, but I didn't give much leeway on tolerances.
Maybe scaling down Z to 96-98% if you print at a larger layer height.
There will probably be an instructable to come.
This should fit any of those coin cell LED strips, this is a common housing, well, that I've seen.
Printed at 1.5mm layer height for mine; I can only assume 2mm would be fine, but I didn't give much leeway on tolerances.
Maybe scaling down Z to 96-98% if you print at a larger layer height.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
