Thingiverse
Collapsible Carrot
by bigovereasy
58
Downloads
245
Likes
1
Makes
This design does not require an AMS ✅
I also made a version without petals (without ears).
To keep the petals closed, I used cylindrical 5x2mm magnets 🧲, which are glued into matching recesses 💧.
As a pin, I use a 25mm piece of filament. If you hold the outer part with the loops facing upward in your left hand, the filament should be inserted into the far right ear.
The filament should slide easily into the first and second ears, but the third hole is tapered (narrowing), so just press the filament firmly until it's fully inserted.
The carrot top is printed separately and screws into the cap.
The cap attaches to the large elbow via a bayonet mount.
Just insert and twist until yo
This design does not require an AMS ✅
I also made a version without petals (without ears).
To keep the petals closed, I used cylindrical 5x2mm magnets 🧲, which are glued into matching recesses 💧.
As a pin, I use a 25mm piece of filament. If you hold the outer part with the loops facing upward in your left hand, the filament should be inserted into the far right ear.
The filament should slide easily into the first and second ears, but the third hole is tapered (narrowing), so just press the filament firmly until it's fully inserted.
The carrot top is printed separately and screws into the cap.
The cap attaches to the large elbow via a bayonet mount.
Just insert and twist until yo
bigovereasy also publishes on
295 additional models across 4 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
