Thingiverse
Collapsible Laptop Stand
door Acamori
0
Downloads
1
Likes
0
Makes
Most of the collapsible laptop stands I've found suffer from being too chunky and setting the laptop at too much of an angle for comfortable typing. So I made my own.
This only has one angle (10deg), but 90% of my usage is at a low angle primarily to facilitate airflow. Other specific angles should be easy enough to add at a later date if needed/requested.
The model is print-in-place on the narrower edge. A bit of help separating the rear support riser on each side helps dislodge it.
This only has one angle (10deg), but 90% of my usage is at a low angle primarily to facilitate airflow. Other specific angles should be easy enough to add at a later date if needed/requested.
The model is print-in-place on the narrower edge. A bit of help separating the rear support riser on each side helps dislodge it.
Acamori publiceert ook op
9 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
